Who is in your network?

The ATTINY85 is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATTINY85 achieves throughputs approaching 1 MIPS per MHz allowing the system designer to optimize power consumption versus processing speed. This article provides you with a basic overview of the ATTINY85 8-bit AVR Microcontroller, including its pin descriptions, features and specifications, etc., to help you quickly understand what ATTINY85 is. If you are interested in how to use ATTINY85 Microcontroller, you can click on the following link:
https://www.utmel.com/componen....ts/how-to-use-attiny

The LM2577 is monolithic integrated circuits that provide all of the power and control functions for step-up (boost), flyback, and forward converter switching regulators. The device is available in three different output voltage versions: 12V, 15V, and adjustable. Requiring a minimum number of external components, these regulators are cost effective, and simple to use. Included on the chip is a 3.0A NPN switch and its associated protection circuitry, consisting of current and thermal limiting, and undervoltage lockout. Other features include a 52 kHz fixed-frequency oscillator that requires no external components, a soft start mode to reduce in-rush current during start-up, and current mode control for improved rejection of input voltage and output load transients. If you are interested in LM2577, you can click on the following link:
https://www.utmel.com/componen....ts/lm2577-voltage-re

The TL082 Op-Amp is a low cost, high speed, dual JFET input operational amplifier with an internally trimmed input offset voltage. This device requires a low supply current yet maintains a large gain bandwidth product and fast slew rate. In addition, well-matched high voltage JFET input devices provide very low input bias and offset currents. If you are interested in where & how to use TL082, you can click on the following link:
https://www.utmel.com/componen....ts/tl082-jfet-dual-o

The LM385 series are micropower two−terminal bandgap voltage regulator diodes. Designed to operate over a wide current range of 10 μA to 20 mA, these devices feature exceptionally low dynamic impedance, low noise and stable operation over time and temperature. The LM385 series are packaged in a low cost TO−226 plastic case and are available in two voltage versions of 1.235 V and 2.500 V as denoted by the device suffix (see Ordering Information table). The LM385 is specified over a 0°C to +70°C temperature range. The LM385 is also available in a surface mount plastic package in voltages of 1.235 V and 2.500 V. This article provides you with a basic overview of the LM385 Voltage Regulator Diode, including its pin descriptions, features and specifications, etc., to help you quickly understand what LM385 is. If you are interested in LM385, you can click on the following link:
https://www.utmel.com/componen....ts/lm385-voltage-reg

The SG3525A Pulse Width Modulator Control circuits, It is a pulse width modulation controller IC which has 16 pins. It provides two pulse width modulator signal which is a complement of each other. It is used to generate a PWM signal for power electronics projects and also for switch-mode power supplies. It offers feedback circuitry to control the output voltage by comparing the feedback signal with a reference voltage. It has a protection circuitry that shutdown the PWM signal based on the feedback current limit. Is SG3525 an ideal new controller at present? How and Where to use SG3525? If you are interested in SG3525A, you can click on the following link:
https://www.utmel.com/componen....ts/sg3525a-pwm-contr